Value Series™ Single Color 21 LED Strip
Our Value Series LED Strips provide an incredibly bright single-color lighting effect from a flexible, sealed strip. Great for both engine and wheel lighting.
Note: The bike pictured has our MEGA TNT Sticks installed on the front and rear wheels.
Light Your Wheels!
Value Series LED strips provide awesome wheel lighting when you wrap a 6 or 9-cluster strip around the edge of most brake calipers. Produces a full 360 degree lighting effect with a single wire lead that runs up your brake line. Makes for a very clean and easy install with no unsightly wires wrapped around your spokes or special discs to install. Just insanely bright wheel lighting at a very affordable price.
Sealed, Flexible Strips
Our Value Series Single Color 21 LED strips are completely sealed against the elements. They are heat resistant, waterproof and easily cleaned for a lifetime of maintenance free operation. The soft, gel-like strips provide maximum flexibility and a clean and sleek appearance. Their low profile design makes them virtually invisible when placed on the bottom of your tank. Their wide viewing angle floods your bike with light. This is truly explosive LED lighting technology.
Cutting the Strips
When cutting a strip you will need to place a piece of the provided heat shrink tubing over the cut ends to make a watertight and insulated seal. Our Installation Instructions Page provides details on how to install the lights and where to cut the strips. Check out the instructions if you are concerned about where to cut the strips.
Value Series Strips vs. Cut N’ Click
While many of our professional installers may still prefer to use our Cut N’ Click Ultimate Engine Kit due to the installation versatility and lifetime warranty of our Cut N’ Click strips, most do-it-yourselfers will find our Value Series LED strips easier to install and maintain. Due to their waterproof design they can be placed inside fenders and in other locations where it is not feasible to place our Cut N’ Click strips.
- Each strip has 21, single color 5050 LEDs
- Physical Dimensions: 20"L x 3/8"w x 1/8"H
- 36" Black, 2-conductor power lead (red and black) on each end
- Draws just 490 milliamps (.49 amps) for the entire strip
- Attaches with 3M double-sided VHB tape already applied to the back of each strip
- Low profile for easy-to-conceal placement
- Waterproof design for trouble-free operation in any condition
- For LUX brightness data on this product visit the Boogey Lights® LUX DATA page.
These 21-LED strips have a wire lead on each end, allowing you to cut the strip into two pieces of 3-cluster multiples. For example, from a single strip you could create an 18-LED cluster strip to place under one side of your tank and a 3-LED cluster strip to place behind your breather. Or, you might cut a 15-LED cluster strip to place on your frame rail for ground effects and a 6-LED cluster strip to place under your oil tank on beneath the seat pan on your Harley.