When we bought the lights we were given the wrong controller for the voltage of our motorhome. It worked a while and then quit but without any problem it was replaced without any questions. I can't thank you enough.
An improved version of our original strobe & breathing remote. Special effects include Flashing, Strobe, and Breathing with 1 hour shut-off timer. (see video below for feature overview). Never run down your battery knowing your lights will turn themselves off in 1 hour when turned on with the remote control. Keychain remotes have sliding cover to prevent accidental press of control buttons.
Remote Control Options:
- Original - Our original model is rated to 100 LEDs - maybe more depending on your installation. That's enough to light most bikes front to back. Controller measures 1-3/4" x 1" x 5/8".
- PLUS Series - Updated to handle more lights. Rated to 300 LEDs - maybe more depending on your installation. Perfect for those who want to light it all up and then some! Controller measures 1-3/4" x 1" x 5/8".
- SUPER Series - We took this up another notch. Rated to 900 LEDs - maybe more depending on your installation. Perfect for Can Am Spyders, Electra Glides, Gold Wings or other large cruisers, trikes and those who pull a trailer and want it lit up. Also works great on golf carts, cars, trucks or any vehicle requiring numerous strips or rolls of lights. The controller is a bit larger at 2-1/2" x 1-3/4" x 7/8".
Note: Our controllers have built in protection against overload, short circuit or reverse polarity situations. If it detects any problems the controller will shutdown and not function until the fault is repaired. While these are rated for a specific number of LED's your particular installation may affect the actual number of LED's you can run on these controllers.
PLEASE NOTE. All Boogey Lights® controllers and LED components are POSITIVE switched devices. They will not work with components that are negatively switched.
Works with all 12v LED products that do not require a special switch or control unit. If adding a manual switch, you must install the switch between the fuse link and the red (positive) LED wire leads. This is a positive-switched unit.
Now with 2 handheld remote control units. Three (3) year warranty.
Wiring diagram using the remote control with our pushbutton switch. You always want to wire a switch with a remote control so you can easily turn your lights off and on while riding. Wiring is the same as for the ON/OFF remote pictured. Water resistant but NOT waterproof. Intended to be installed in a location protected from water.
The product is good, but the people are better! Highly recommended.