Corvette C8 Mid-Engine LED Light Kit

Install Resources
Current Stock:
size: 12.00 W × 12.00 H × 12.00 L

Check out the Lighting Builder for a more customized experience.

Lighting Builder

OOS Message

OOS Message

Corvette C8 Mid-Engine LED Light Kit

Light up your C8 with a Boogey Lights® Mid-Engine LED light kit! Our super bright, low profile LED strips are built tough to withstand harsh operating environments. And with more LEDs per inch than any other LED light strip on the market, nothing is brighter! This kit has six super bright low profile LED lights that absolutely flood the mid-engine bay area with light (see photos). Available in your choice of single color, dual color and multi-color RGB, RGBx and RGBXX. Input voltage is 12vdc. LED light strips are constructed with 2 ounce copper PCB with 1.2mm of industrial strength 3M adhesive tape. 3M promoter included ensure these lights will stay stuck. LEDs are hi-intensity super-bright 5050 LEDs based on our low-profile surface mounted LED strips.

The single color version of this kit can be wired directly into or off an existing switch if desired; or, add a wireless on/off remote. Same with the dual color option although you'll need 2 switches (one for each color). The RGB/Multi-Color versions requires an LED controller to operate; make your selection from the drop down box above. The RGB, RGBx and RGBxx LED Controllers offered are our popular COMBO RF + BLUETOOTH LED controllers. These COMBO controllers include both an RF wireless remote AND a Bluetooth APP so you can use your phone to control the ligths too. See the CONFIGURATION TAB for more detail on these color and controller options. The kit as configured includes the following LED strips:

  • 3 - 12" each with a 5' power lead
  • 3 - 15.75" each with a 5' power lead

See product photo carousel for installation placement. Total amperage draw should be no more than 2 amps when using the brightest setting (assumes white). Other colors will use less amperage.

Be sure to read the CONFIGURATIONS and COLOR OPTIONS Navigation Tabs on this product page. These pages provide significantly more detail about the LED COLOR and KIT CONFIGURATION options presented.

NOTE: This product offers both our GEN1 and our new GEN2 LED Controller Options. Click the G1 VS G2 navigation tab on this product page for specifics.


Light kit includes 6 - LED strips in the lengths specified.
Each LED strip includes a 5' power lead.
Optional Switching and LED Controller options available to support your choice of LED color.
Install supplies including 3m Adhesion Promoter, split-wire loom, zip ties, battery connector wire, fuse holder, butyl and power lead extension cable as needed.

OTHER ITEMS YOU MAY NEED TO COMPLETE YOUR INSTALL. No two installation scenarios are the same. Not everyone shares the same installation quality goals. Some folks are OK with twisting wires together, others want to solder them. Some folks are OK with running wires where they may be seen or unprotected to save money/time, others want a tidy, clean install without any wires showing. Some folks are OK with mounting their LED strips to whatever surface they can find, others want to take the time necessary to build out appropriate mounting surfaces to provide the best lighting effect on their vehicle. The point is it's not possible to provide all the materials necessary for all installation scenarios and quality goals. Our light kits provide the essential components needed for a high-quality, functioning lighting system. Installation of our light kit to your specific vehicle may however require additional items to make it look and fit the way you want. This is particularly the case with electrical wiring and mounting of LED strips. Before proceeding with your installation we suggest you consider THESE OTHER ITEMS you may need.

Note: All Boogey Lights® RGB LED strips are COMMON CATHODE LEDS. They share a common ground and will only work with positively switched controllers. Most LED strips on the market today are COMMON ANODE because the controller technology used to power them is less expensive to manufacture. However they're not nearly as bright and are an overall inferior design when compared with COMMON CATHODE LEDs.